Spot & Stain Remover, Carpet
Quality for less. All You Need for: pet stains; tracked-in dirt; motor oil; food grease; coffee/tea; red wine and more! With StainBlock protection. Formula 409 Carpet Spot & Stain Remover's fast-penetrating formula effectively cleans the whole carpet and gets out a variety of tough stains. Formulated with Formula 409 stain lifters, Formula 409 Carpet Spot & Stain Remover penetrates deep into carpet fibers and safely removes dirt and odors. 409 Carpet Spot & Stain Remover has StainBlock to help repel dirt and stains so next time it's easier to clean. Formula 409 Carpet Spot & Stain Remover leaves your carpet clean, soft and plush. Safe for use in pet areas. Safe for use on carpets made of nylon and other synthetics and on stain resistant carpets. If accidentally sprayed on furniture or baseboard, just wipe off. Contents will clean a carpeted area up to 168 square feet (12 x 14 feet). Contains no CFCs which deplete the ozone layer. No CFCs. Contains no phosphorus. Made in the USA.
Contains: Contents under pressure. Do not puncture or incinerate container. Do not expose to heat or store at temperatures above 120 degrees F since container may burst. Avoid eye contact and prolonged contact with skin. First Aid: Eyes or skin - Rinse with water. If swallowed - Drink a glassful of water. Call a doctor or poison control center. Keep out of reach of children. Contains: Anionic surfactants and fragrance.
Before Cleaning: Test for colorfastness on a hidden section of carpet. Remove loose dirt from the area to be cleaned. For wet spills or stains, blot area with a clean, absorbent cloth. Some stains will cause permanent discoloration even after cleaning. Spot and stain cleaning. 1. Shake can well and generously apply Formula 409 Carpet Spot & Stain Remover directly to stain from a distance of 4 to 6 inches. Allow foam to absorb into stain for 3 minutes. 2. Gently rub or blot area with an absorbent, dry cloth. Repeat steps 1 and 2 as needed. 3. Allow to dry completely and then vacuum. Deep-Cleaning for Larger Areas: 1. Shake well before and during use. Hold can upside down about 2 feet above carpet. Spray lightly and evenly over a 3-foot-square area using a side-to-side sweeping motion. 2. With a damp mop or sponge, rub into carpet using a crisscross sweeping motion. 3. Continue working across the carpet until entire area is cleaned. Let dry, then vacuum loosened dirt. Self-Cleaning: 1. Shake can well before and during use. Hold can upside down about 2 feet above carpet. Spray lightly and evenly using a side-to-side sweeping motion. 2. Allow approximately 15 minutes for foam to dry and to lift dirt. When dry, vacuum thoroughly. For best results, use vacuum cleaner at top suction with a fresh empty bag. Disposal: Offer empty container for recycling. If recycling is not available, discard container in trash.
About the Producer